Tag: Miter Sled
-
I’ve finally completed the miter sled, but not without some issues. I had to sand down the rails quite a bit more so that they would slide without sticking. Then I applied a liberal layer of paste wax to the bottom of the sled and to the surface of the table saw. This will lower…
-
I finally got the bench top planer out to process the 2x4s for the miter sled. It is nice planing down the thickness of pine because it is so fast and it ends up being a pretty flat edge. I am a big fan of pine, by the way. I took a second to make…
-
I picked up pre-cut 2x4s at the hardware store for the sled fences. I measured and cut them down to length of the plywood. The rails needed a good sanding to get any glue from the push out. I ended up just pulling the finishing nails because it felt like they did their job. I…
-
I’ve been wanting to do a miter sled for a long time. I have a cross cut sled and I use it constantly and in fact, my Ryobi table saw is almost exclusively for cross cuts after I got the Craftsman from my father. However, I’ve always struggled with 45s on the table saw and…